Numerical Modeling of Temperature and Pressure Fields in an Enclosure with Two Openings in Natural Convection

Authors

  • Toko Christian Anicet Koueni Department of Renewable Energy, ENSPM, University of Maroua, P. O. Box 46 Maroua, Cameroon

DOI:

https://doi.org/10.14738/tmlai.1301.18300

Keywords:

Enclosure with aspect ratio less than 1, Natural convection, Solid heat source, Temperature fields, Pressure fields, Numerical calculation

Abstract

This work numerically studies the temperature and pressure fields generated by a solid heat source in an enclosure with an aspect ratio H/L = 0.82 having two symmetrical low openings in natural convection. The enclosure has a height H = 520 mm, a length L = 630 mm and a width l = 210 mm. The heat source is cylindrical with a diameter D0 = 20 mm and a length l = 210 mm. 04 values ​​of the power per unit length were imposed on the heat source corresponding to 04 reduced Rayleigh numbers 0.59 × 1011, 1.78 × 1011, 2.19 × 1011 and 2.57 × 1011. 03 CAS 21, CAS 22, CAS 23 enclosures different by the position of the heat source were studied. In CAS 21, the heat source is at position x+ = 0.24, in CAS 22 at x+ = - 0.24 and in CAS 23 at position x+ = 0. The study was carried out in steady state. Numerical studies were conducted by DNS considering that the heat source is at constant power per unit length. Numerical results show that in CAS 23 and whatever the values ​​of the reduced Rayleigh number, the thermal plume is centered at a higher temperature than that of the environment outside the plume. The thermal plume is generated by turbulent natural convection. Its initial speed is a function of the speed of fresh air entering the enclosure through the openings and its initial temperature is a function of the reduced Rayleigh number. The gas movements at the openings are created by the static pressure difference between the inside and outside of the enclosure. In the CAS 21 enclosure, the thermal plume is deflected from x+ > 0 and in CAS 22 from x+ < 0. This deflection of the thermal plume towards one of the side walls of the enclosure may be due to the Coanda effect. The numerical results of the temperature and the differential static pressure agree with the experimental measurements.

References

Le Masson S., Nortershauser D., Deddy B., Glouannec P. (2011) Thermal model for data centre cooling, Telecommunications Energy Conference (INTELEC), 33rd International IEE

Quintiere J. G. (2000) Enclosure Fire Dynamics, CRC Press LLC, Boca Raton USA

Quintiere, J. G., Rinkinen, W. J., Jones, W. W. (1981) Effect of Room Openings on Fire Plume Entrainment, Combustion Science and Technology, 26, 5-6, 193-201

Koueni Toko C. A. (2019), Etude des champs dynamique et thermique dans une enceinte semi – ventilée en convection naturelle, Rapport annuel de thèse – CORIA

Kouéni-Toko C. A., Tcheukam – Toko D., Kuitche A., Patte-Rouland B., Paranthoën P. (2020), Numerical modeling of the temperature fields in a semi-confined enclosure heated by a linear heat source, International Journal of Thermofluids, 100017. https://doi.org/10.1016/j.ijft.2020.100017

Kouéni Toko Christian Anicet (2022), Numerical Simulation of the Velocity Fields Generated by a Plume in Enclosure with Several Openings, International Journal of Fluid Mechanics & Thermal Sciences, 7(4), 53 – 67 doi: 10.11648/j.ijfmts.20210704.11

Kouéni – Toko Christian Anicet, Patte-Rouland Béatrice, Paranthoën Pierre. (2022), Experimental Study of the Pressure Generated by a Linear Heat Source in a Semi–ventilated Enclosure, Engineering and Applied Sciences, 7(1), 8 – 15 doi: 10.11648/j.eas.20220701.12

Koueni – Toko Christian Anicet (2022). Study of Thermal Fields in a Semi – Ventilated Enclosure Heated by a Linear Heat Source. International Journal of Fluid Mechanics & Thermal Sciences, 8(3), 53 – 63

Koueni, T. C. A. (2024). Natural Ventilation in a Semi-Confined Enclosure Heated by a Linear Heat Source.

Yu E., Yoshi Y. (1997) A numerical study of three-dimensional laminar natural convection in a vented enclosure, International Journal of Heat and Fluid Flow, 18, 6, 800-812

Jilani G., Jayaraj S., Khadar K. (2002) Numerical analysis of free convective flows in partially open enclosure, Heat and Mass Transfer, 38, 261-270

Desrayaud G., Lauriat G. (2004) A numerical study of natural convection in partially open enclosures with a conducting side-wall, J. Heat Transfer, 126, 1, 76-83

Miyamoto M., Kuehn T. H., Goldstein R.J., Katoh Y. (1989), Two-dimensional laminar natural convection heat transfer from a fully or partially open square cavity, Numerical Heat Transfer, Part A, 15, 4, 411-430

Prakash M., Kedare S. B., Nayak J. K. (2012) Numerical study of natural convection loss from open cavities, International Journal of Thermal Sciences, 51, 23-30

Baines W. D., Turner J. S. (1969) Turbulent buoyant convection from a source in a confined region, Journal of Fluid Mechanics, 37, 51-80

Morton B. R., Taylor G. I., Turner J. S. (1956), Turbulent gravitational convection from maintained and instantaneous sources, Proc. Roy. Soc. London, A, 234, 1 – 23

Patankar S. V. (1980), Numerical heat transfert and fluid flow, Hemisphere Publishing Corporation

Leonard, B. P. (1979), A stable and accurate convective 146odeling procedure based on quadratic interpolation, Comput methods Appl. Mech. Eng., 19, 59 – 98

Bouafia M., Daube O. (2007), Natural convection for large temperature gradients around a square solid body within a rectangular cavity, International Journal of Heat and Mass Transfer, 50, 3599 – 3615

Downloads

Published

2025-02-25

How to Cite

Koueni, T. C. A. (2025). Numerical Modeling of Temperature and Pressure Fields in an Enclosure with Two Openings in Natural Convection. Transactions on Engineering and Computing Sciences, 13(01), 124–146. https://doi.org/10.14738/tmlai.1301.18300