Mechanochemical Synthesis and Characterization of Samarium Oxide-Hematite Magnetic Ceramic Nanostructures

Authors

  • Monica Sorescu Duquesne University, Department of Physics, Fisher Hall, Pittsburgh, PA 15282, United States
  • Lona Adams Duquesne University, Department of Chemistry and Biochemistry, Mellon Hall, Pittsburgh, PA 15282, United States
  • Felicia Tolea National Institute of Materials Physics, Bucharest-Magurele, 077125, Romania
  • Mihaela Sofronie National Institute of Materials Physics, Bucharest-Magurele, 077125, Romania
  • Jordan C Kelly Duquesne University, Department of Chemistry and Biochemistry, Mellon Hall, Pittsburgh, PA 15282, United States
  • Jennifer A Aitken Duquesne University, Department of Chemistry and Biochemistry, Mellon Hall, Pittsburgh, PA 15282, United States

DOI:

https://doi.org/10.14738/aivp.126.18060

Keywords:

oxides, Mossbauer spectroscopy, magnetic properties, optical properties

Abstract

Mixed-oxide nanostructures of the type xSm2O3-(1-x)alpha-Fe2O3 (x=0.1 and 0.5) were synthesized by mechanochemical activation for ball milling times of 0, 2, 4, 8 and 12 hours. The 0-h Mӧssbauer spectrum was analyzed with a sextet characteristic to hematite. A second sextet with a lower value of the hyperfine magnetic field was assigned to samarium-doped hematite. An additional quadrupole-split doublet, whose abundance showed a general trend to increase with the ball milling time, was attributed to superparamagnetic samarium iron perovskite (samarium orthoferrite) phase. The X-ray diffraction (XRD) patterns for the equimolar composition were dominated by the diffraction peaks of SmFeO3 after 12 h of milling. The hysteresis loops recorded at 5 K and an applied magnetic field of 5 T exhibited higher values of the magnetization than the similar ones measured at 300 K, but did not saturate at this field strength. The coercive field values showed a decrease with decreasing the particle size after prolonged milling. The zero-field-cooling-field-cooling (ZFC-FC) measurements performed at 200 Oe and 5-300 K were consistent with an increase in magnetization with ball milling time. The Tauc plots derived from the optical diffuse reflectance spectra showed that the samples were semiconductors with a band gap of ~2.1 eV.

References

Rana, K., et al., Influence of samarium doping on magnetic and structural properties of M type Ba–Co hexaferrite, Ceramics International, 2016.42: p.8413-8418. http://dx.doi.org/10.1016/j.ceramint.2016.02.058

Srinivasamurthy, K.M., et al., Evidence of enhanced ferromagnetic nature and hyperfine interaction studies of Ce-Sm doped Co-Ni ferrite nanoparticles for microphone applications, Ceramics International, 2018.44: p.18878-18885. https://doi.org/10.1016/j.ceramint.2018.07.123

Silva, R.L., et al., Surface effect in PVP coated Sm doped magnetite nanoparticles prepared by the polyol method, Ceramics International, 2018.44: p.13050-13054.

Tijerina-Rosa, A., et al., Partial substitution of cobalt by rare-earths (Gd or Sm) in cobalt ferrite: Effect on its microstructure and magnetic properties, Ceramics International, 2019. 45: p. 22920-22929.

Lin, Q., et al., Effect of substitution on the structural and magnetic properties of Sm3+- doped / SmFeO3 in nickel-copper-zinc mixed ferrite nanoparticles, Ceramics International, 2020. 46: p. 2523-2529.

Badapanda, T., et al., Structural and impedance spectroscopy study of Samarium modified Barium Zirconium Titanate ceramic prepared by mechanochemical route, Current Applied Physics, 2014. 14: p. 1192-1200. http://dx.doi.org/10.1016/j.cap.2014.06.007

Husain, K., et al., Samarium substituted M-type Ca-hexaferrites: Structural and magnetic features, Inorganic Chemistry Communications, 2024. 165: 112493. https://doi.org/10.1016/j.inoche.2024.112493

Suryanarayana, B., et al., Effect of Sm3+ substitution on dc electrical resistivity and magnetic properties of Ni–Co ferrites, Journal of the Indian Chemical Society, 2022. 99: 100623. https://doi.org/10.1016/j.jics.2022.100623

Romero, M., et al., Effect of lanthanide on the microstructure and structure of LnMn Fe O nanoparticles 0.5 0.5 3 with Ln=La, Pr, Nd, Sm and Gd prepared by the polymer precursor method, Journal of Solid State Chemistry, 2015. 221: p. 325-333. http://dx.doi.org/10.1016/j.jssc.2014.10.028

Al-Haj, M., Structural characterization and magnetization of Mg Zn SmFe O ferrites, Journal of 0.7 0.3 x 2-x 4 Magnetism and Magnetic Materials, 2006. 299: p. 435-439. doi:10.1016/j.jmmm.2005.05.003 3+

Nhlapo T.A. and Moyo, T., The effect of particle size on structural and magnetic properties of Sm ion substituted Zn-Mn nanoferrites synthesized by glycol-thermal method, Journal of Magnetism and Magnetic Materials, 2020. 513: 167096. https://doi.org/10.1016/j.jmmm.2020.167096

Shan, S., et al., Magnetic properties of Sm-doped M-type barium ferrite by high-energy ball mill-assisted solidphase reaction method, Journal of Magnetism and Magnetic Materials, 2024. 589: 171558. https://doi.org/10.1016/j.jmmm.2023.171558

Zhang, J., et al., Structural, micro-structure, magnetic and dynamic magneto-elastic properties of samariumdoped nickel-zinc spinel ferrites for efficient power conversion applications, Journal of Magnetism and Magnetic Materials, 2024. 602: 172176. https://doi.org/10.1016/j.jmmm.2024.172176

Pakalniskis, A., et al., Pressure induced phase transitions in Sm-doped BiFeO3 in the morphotropic phase boundary, Materials Chemistry and Physics, 2022. 277: 125458. https://doi.org/10.1016/j.matchemphys.2021.125458

Yuvaraj, S., et al., Electrical and magnetic properties of spherical SmFeO3 synthesized by aspartic acid assisted combustion method, Materials Research Bulletin, 2015.72: p. 77-82. http://dx.doi.org/10.1016/j.materresbull.2015.07.013

Huizar-Felix, A.M., et al., Sol–gel based Pechini method synthesis and characterization of Sm Ca FeO 1− x x 3 perovskite 0.1≤x≤0.5, Powder Technology, 2012.229: p. 290-293. doi:10.1016/j.powtec.2012.06.057

Smith, P.A.I., et al., Mechanically alloyed Sm-(Co-Fe) permanent magnets, Scripta Materialia, 1996. 34: p.61-66.

J.P. Hos and P.G. McCormick, Mechanochemical synthesis and characterization of nanoparticulate samarium-doped cerium oxide, Scripta Materialia, 2003, 48, 85-90.

Dos Santos Bernardino, R.L., et al., Mechanical alloying synthesis and comprehensive characterization of SmCoO3 perovskite through XRD, XRF, DSC, and UVVis absorbance, Solid State Sciences, 2024. 151: 107503. https://doi.org/10.1016/j.solidstatesciences.2024.107503

Iordanova, N., et al., Charge transport in metal oxides: A theoretical study of hematite a-Fe O , Journal of Chemical Physics, 2005. 122: 144305. https://doi.org/10.1063/1.1869492 2 3

Rozenberg, G.Kh., et al., High pressure structural studies of hematite Fe2O3, Physical Review B, 2002. 65: 064112. https://doi.org/10.1103/PhysRevB.65.064112

Bergenmayer, W., et al., Ab Initio thermodynamics of oxide surfaces: O2 on Fe2O3 (0001), Physical Review B, 2004. 69: 195409. https://doi.org/10.1103/PhysRevB.69.195409

Zheng, Y., et al., Quasicubic a-Fe O nanoparticles with excellent catalytic performance, Journal of Physical Chemistry B, 2006. 110: p. 3093-3097. https://doi.org/10.1021/jp056617q

Wu, C., et al., Synthesis of hematite (a-Fe O ) nanorods: Diameter-size and shape effects on their applications in magnetism, lithium ion battery, and gas sensors, Journal of Physical Chemistry B, 2006. 110: p.17806-17812. doi:10.1021/jp0633906

Liu, J.Z., Morin transition in hematite doped with Iridium ions, Journal of Magnetism and Magnetic Materials, 1986. 54-57: p. 901-902.

Stroh, C., et al., Ruthenium oxide-hematite magnetic ceramics nanostructures, Ceramics International, 2015. 41: p. 14367-14375. https://doi.org/10.1016/j.ceramint.2015.07.070

Glasser, S., et al., Effects of mechanochemical activation on the structural, magnetic and optical properties of yttrium iron garnet-graphene nanoparticles, Physica B, 2023. 650: 414501. doi:10.1016/j.physb.2022.414501

Sorescu, M., et al., Formation of skyrmion phase in the Fe-Co-Si system by mechanochemical activation, Physica B, 2024. 688: 416153. doi:10.1016/j.physb.2024.416153

Glasser, S., et al., Synthesis and characterization of gadolinium oxide-hematite magnetic ceramic nanostructures, Journal of Minerals and Materials Characterization and Engineering, 2023. 11: p. 1-15. doi:10.4236/jmmce.2023.111001

Sorescu, M., et al., Mechanochemical synthesis and Mӧssbauer characterization of neodymium oxide-hematite magnetic ceramic nanoparticles: Phase sequence and recoilless fraction, Materials Chemistry and Physics, 2022. 277: 125511. https://doi.org/10.1016/j.matchemphys.2021.125511

Mora-Ramirez, M.A., et al., Optical emission bands of Sm O and their link with crystalline defects and 4fd4fd electronic transitions at UV-Vis region, Optik, 2021. 241: 167211. doi:10.1016/j.ijleo.2021.167211

Tauc, J., et al., Optical properties and electronic structure of amorphous germanium, Physica Status Solidi, 1966. 15: p. 627.

Mallick, P. and Dash, B.N., X-ray diffraction and UV-Visible characterizations of a-Fe2O3 nanoparticles annealed at different temperature, Nanoscience and Nanotechnology, 2013. 3: p. 130-134. doi:10.5923/j.nn.20130305.04

Downloads

Published

2024-12-25

How to Cite

Sorescu, M., Adams, L., Tolea, F., Sofronie, M., Kelly, J. C., & Aitken, J. A. (2024). Mechanochemical Synthesis and Characterization of Samarium Oxide-Hematite Magnetic Ceramic Nanostructures. European Journal of Applied Sciences, 12(06), 693–708. https://doi.org/10.14738/aivp.126.18060