Kinetics of Oven Drying of Ocimum basilicum Leaves Harvested at Different Ages of Maturity

Authors

  • Jeantia Michaely Matoko Badila Department of Food Chemistry and Technology, Faculty of Science and Techniques, (UMNG), Congo
  • Eliane Thérèse Biassala Department of Food Chemistry and Technology, Faculty of Science and Techniques, (UMNG), Congo
  • Célestine Kiminou Ngounga Process Engineering Laboratory, UNESCO-ENSP Chair, UMNG. Congo
  • Danielle Gobet Department of Food Chemistry and Technology, Faculty of Science and Techniques, (UMNG), Congo
  • Thomas Silou Department of Food Chemistry and Technology, Faculty of Science and Techniques, (UMNG), Congo and Higher School of Technology Les Cataractes BP: 389, Brazzaville, Congo

DOI:

https://doi.org/10.14738/aivp.123.17053

Keywords:

Drying temperature, Drying kinetics, Modeling, Ocimum basilicum, water content

Abstract

Drying is a unitary operation that involves the simultaneous transfer of heat and humidity to reduce the water content of products to a safe level. This work therefore aims to study the characteristics of drying in an oven through the effect of temperature and drying time on Ocimum basilicum leaves harvested at different stages of maturity and to adapt the drying data into ten mathematical models to determine which one is best validated by experimental data. The leaves studied were collected at well-defined time intervals corresponding to the level of growth or maturity of the plants, i.e. one month, two months and three months. Drying was carried out using a natural convection oven at temperatures of 70, 80 and 90 °C. The water content varied from 80 to 86% depending on the age of the leaves. The drying speed was rapid at the beginning of the process and decreased after 60 min. The coefficient of determination and chi-square were used as statistical parameters for comparing the accuracy of the models. The Wang and Sing and Exponential models gave a better fit and better validated the experimental data compared to the other models whatever the temperature and age of the leaves.

References

Akpinar, E.K (2006). Mathematical modeling of thin layer drying process under open sun of some aromatic plants. Journal of food Engineering, London, 77(4): 864-870;

Amenaghawon NA, Okhueleigbe KE, Ogbeide SE and Okieimen CO. (2014). Modelling the kinetics of steam distillation of essential oils from lemon grass (Cymbopogon spp) International Journal of Applied Science and Engineering, 12 (2): 107-115.

Ammann Hinz DC, Addlemen RS, Wai CM,Wenclawiak BW. (1999). Super-heated water extraction, steam distillation and SFE of pipermint oil Fresenus. J. Anal. Chem., 364: 650-653. 16

Babu, G.D.K., Singh, B. (2009). Simulation of Eucalyptus cinerea oil distillation: A study on optimization of 1,8-cineole production. Biochem. Eng. J., 44: 226 – 231.

Cassel E, Vargas RMF, Martinez N, Lorenzo D, Dellacassa E. (2009). Steam distillation modeling for essential oil extraction process. Industrial Crops Products, 29: 171 – 176.

Cassel E., and Vergas R.M.F. (2006). Experiments and modeling of the the Cymbopogon winterianus essential oil extraction by steam distillation. Journal of the Mexican Chemical Society, 50 (3): 126-129.

Farhana E.N., Lutfi N.A., Atan F.M., Rahman N.A., Salleh S.F., Wahab N.A. (2016). Study on distillation. Journal of Applied Sciences & Process Engineering, 3 (1): 1-16.

Fudholi, A., Ruslan, M. H., Haw, L. C., Mat, S., Othman, M. Y., Zaharim, A., Sopian, K., (2012). Mathematical modeling of brown seaweed drying curves. Proceedings of the WSEAS International Conference on Applied Mathematics in Electrical and Computer Engineering. pp. 207–211.

Golmakani MT, Rezael K. (2008). Comparison of microwaves assisted hydrodistillation with the traditional hydrodistllation method in the extraction of essential oils from Thymus vulgaris J. Food Chem. 109: 925-930.

Kabuba J. (2013). Development of mathematical model extraction for extraction process of essential oils from Eucalyptus leaves; International Conference on Chemical Mining and Metallurgical Engeineering (CMME 2013). November 27-28 Johannesburg South Africa.

Keneni Y. G., Hvoslef-Eide A. K. (Trine), Marchetti J. M., (2019). Mathematical modelling of the drying kinetics of Jatropha curcas L. seeds. Industrial Crops & Products 132, 12– 20.

Kivaandra D. R. R., Zuliana R., Chandran S. (2021). Mathematical models to describe the drying process of Moringa oleifera leaves in a convective-air dryer.

Koul V.K., Gandotra B.M., Koul S., Ghosh S., Tikoo C.L., Gupta A.K., (2004). Steam distillation of lemon grass (Cymbopogon spp.). Indian Journal of Chemical Technology, 11: 135-139.

Makri S., and Kintzios O. (2007). Ocimum sp. (Basil): Botany, Cultivation, Pharmaceutical Properties, and Biotechnology Journal of Herbs, Spices & Medicinal Plants, 13(3): 123-150.

Mambou L. B., Loumouamou B. W., Dwondo G. M. (2023). Drying Kinetics of Oven Dried Pellonula leonensis Fish from Congo River. Americain journal of Chemical Engineering. Vol. 11, No. 2, 2023, pp. 39-45. doi: 10.11648/j.ajche.20231102.12.

Mujumdar A. S. and Menon A. S., (1995). “Drying of solids: Principles, classification, and selection of dryers,” in Handbook of Industrial Drying, A. S. Mujumdar, Ed., 2nd ed., Marcel Dekker, New York, vol. 1, pp. 1-39.

Perea-Flores, M., Garibay-Febles, V., Chanona-Perez, J.J., Calderon-Dominguez, G., Mendez-Mendez, J.V., Palacios-Gonza lez, E., Gutierrez-Lopez, G.F., (2012). Mathematical modelling of castor oil seeds (Ricinus communis) drying kinetics in fluidized bed at high temperatures Ind. Crops Prod. 38, 64–71.

Premi M., Sharma H., Upadhayay A., (2012). effect of air velocity and temperatures on the drying kinetics of drumstick leaves (Moringa oleifera). International Journal of Food Engineering.

Sarra M. et Mabrouk S.B., (2012). Analyse cinétique du séchage convectif du Romarin sous des conditions constantes et variables. Congrès International sur les énergies Renouvelables et Environnement. Hammamet, Tunisie.

Sowbhagya H. B., Sampathu S.R., Krishnamurthy N. (2007). Evaluation of size reduction on the yield of celery seed oils. J. Food Eng. 80: 1255-1260. (4), pp. 196-202.

Stanojevic L., Stankovi M., Cakic M., Nikolic L., Ilic D., Radulovic (2011). The effect of hydrodistillation techniques on yeild, kinetics, composition and anti-microbial activity of essential from flowers of Lavandula officinal L. Hem. Ind. 65: 455-463.

Thanh N.D.B., Duc T.H., Dung N.T., (2017). Kinetics and modeling of oil extraction from Vietnam lemongrass by steam distillation Vietnam Journal of Science and Technology 55 (5A) 58-65.

Touati. B., (2001). Modélisation numérique des transferts couplés de la chaleur et de masse lors du séchage des feuilles de menthe. Thèse de Magistère. Centre Universitaire Bechar, Algérie.

Velickovic D., Risic M., Stojilkovic D., (2001). Kinetics for obtaining the essential oil by different technical procedures from flowers, leaves stems of sage (Salvia officinalis). Lek. Sirov. 67-72.

Downloads

Published

2024-06-10

How to Cite

Badila, J. M. M., Biassala, E. T., Ngounga, C. K., Gobet, D., & Silou, T. (2024). Kinetics of Oven Drying of Ocimum basilicum Leaves Harvested at Different Ages of Maturity. European Journal of Applied Sciences, 12(3), 278–291. https://doi.org/10.14738/aivp.123.17053